Dell PowerEdge M605 - Manual (Page 530)

526 VLAN Commands
www
.dell.com | support.dell.com
• remove vlan-list—List of valid VLAN IDs to remove from the forbidden list. Separate
nonconsecutive VLAN IDs with a comma and no spaces. Use a hyphen to designate a
range of IDs.
Default Configuration
All VLANs allowed.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example forbids adding VLAN numbers 234 through 256 to port 1/g8.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport forbidden vlan add 234-256
switchport general acceptable-frame-type tagged-only
Use the switchport general acceptable-frame-type tagged-only command in Interface
Configuration mode to discard untagged frames at ingress. To enable untagged frames at ingress,
use the no form of this command.
Syntax
switchport general acceptable-frame-type tagged-only
no switchport general acceptable-frame-type tagged-only
Default Configuration
All frame types are accepted at ingress.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures 1/g8 to discard untagged frames at ingress.
console(config)#interface ethernet 1/g8