Dell PowerEdge M605 - Manual (Page 729)

OSPFv3 Commands 735
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the OSPF area to which VLAN 15 belongs.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf areaid 100
ipv6 ospf cost
Use the ipv6 ospf cost command in Interface Configuration mode to configure the cost on an
OSPF interface.
Syntax
ipv6 ospf cost cost
no ipv6 ospf cost
• cost—Cost for OSPF interface. (Range: 1-65535)
Default Configuration
10 is the default value of cost.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a cost of 100.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf cost 100
ipv6 ospf dead-interval
Use the ipv6 ospf dead-interval command in Interface Configuration mode to set the OSPF dead
interval for the specified interface.