Dell PowerEdge M605 - Manual (Page 396)

384 QoS Commands
www
.dell.com | support.dell.com
Syntax
show diffserv service brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to display all interfaces in the system to which a DiffServ
policy has been attached.
console# show diffserv service brief
Interface Direction OperStatus Policy Name
----------- ----------- ------------ -------------------
1/g1 in Down DELL
show interfaces cos-queue
Use the show interfaces cos-queue command in Privileged EXEC mode to display the
class-of-service queue configuration for the specified interface.
Syntax
show interfaces cos-queue [/|port-channel port-channel
number]
• /—Specifies a valid unit/port combination:
—Physical switch identifier within the stack. Values are 1-12.
— Values are g for gigabit Ethernet port, or xg for 10 gigabit Ethernet port.
—port number. Values are 1-24 or 1-48 in the case of port_type g, and 1-4 for
port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
• port-channel number—Specifies a valid port-channel number. Range is 1-8.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode