Dell PowerEdge M605 - Manual (Page 84)

46 Command Groups
www
.dell.com | support.dell.com
Router Discovery Protocol Commands
Routing Information Protocol (RIP) Commands
show ip pimsm rp Displays PIM information for candidate Rendezvous
Points (RPs) for all IP multicast groups or for the specific
group address or group mask provided in the command. PE
show ip pimsm rphash Displays the RP router being selected from the set of active
RP routers. PE
show ip pimsm staticrp Displays the static RP information for the PIM-SM router. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
ip irdp Enables Router Discovery on an interface. IC
ip irdp address Configures the address that the interface uses to send the
router discovery advertisements. IC
ip irdp holdtime Configures the value, in seconds, of the holdtime field of
the router advertisement sent from this interface. IC
ip irdp maxadvertinterval Configures the maximum time, in seconds, allowed
between sending router advertisements from the interface. IC
ip irdp minadvertinterval Configures the minimum time, in seconds, allowed
between sending router advertisements from the interface. IC
ip irdp preference Configures the preference of the address as a default router
address relative to other router addresses on the same
subnet. IC
show ip irdp Displays the router discovery information for all interfaces,
or for a specified interface. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
auto-summary Enables the RIP auto-summarization mode. RIP
default-information originate Controls the advertisement of default routes. RIP
default-metric Sets a default for the metric of distributed routes. RIP
distance rip Sets the route preference value of RIP in the router. RIP
Command Description Mode*