Dell PowerEdge M605 - Manual (Page 763)

PIM-SM Commands 771
Example
The following example configures the CBSR preference of 5 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip pimsm cbsrpreference 5
ip pimsm crppreference
Use the ip pimsm crppreference command in Interface Configuration mode to configure the
Candidate Rendezvous Point (CRP) for a particular PIM-SM interface. The active router interface,
with the highest IP Address and crppreference greater than -1, is chosen as the CRP for the router.
In the CRP advertisements sent to the bootstrap router (BSR), the router interface advertises itself
as the CRP for the group range 224.0.0.0 mask 240.0.0.0.
Syntax
ip pimsm crppreference preference
no ip pimsm crppreference
preference—CPR preference. (Range: The valid values are from -1 to 255. The value of -1 is
used to indicate that the local interface is not a Candidate RP interface.)
Default Configuration
0 is the default value for CPR preference.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a Candidate Rendezvous Point (CRP) of 5 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip pimsm crppreference 5
ip pimsm message-interval
Use the ip pimsm message-interval command in Global Configuration mode to configure the
global join/prune interval for PIM-SM router.