Dell PowerEdge M605 - Manual (Page 756)

764 PIM-DM Commands
www
.dell.com | support.dell.com
Syntax
ip pimdm mode
no ip pimdm mode
Default Configuration
Disabled is the default state.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets administrative mode of PIM-DM to enabled for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip pimdm mode
ip pimdm query-interval
Use the ip pimdm query-interval command in Interface Configuration mode to configure the
transmission frequency of hello messages between PIM enabled neighbors.
Syntax
ip pimdm query-interval seconds
no ip pimdm query-interval
• seconds—Transmission frequency. (Range: 10-3600 seconds)
Default Configuration
30 seconds is the default value.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the transmission frequency of hello messages at 50 seconds
for VLAN 15.