Dell PowerEdge M605 - Manual (Page 229)

LACP Commands 201
LACP Commands
lacp port-priority
Use the lacp port-priority command in Interface Configuration mode to configure the priority
value for physical ports. To reset to default priority value, use the no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
• value—Port priority value. (Range: 1 - 65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the priority value for port 1/g8 to 247.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#lacp port-priority 247
lacp system-priority
Use the lacp system-priority command in Global Configuration mode to configure the Link
Aggregation system priority. To reset to default, use the no form of this command.