Dell PowerEdge M605 - Manual (Page 613)

IP Routing Commands 617
Example
The following example identifies the ip-address subnet-mask, next-hop-ip and a preference
value of 200.
console(config)#ip route 192.168.10.10 255.255.255.0 192.168.20.1
metric 200
ip route default
Use the ip route default command in Global Configuration mode to configure the default route.
Use the no form of the command to delete the default route.
Syntax
ip route default [next-hop-ip] [preference]
no ip route default [next-hop-ip [preference]
• next-hop-ip—IP address of the next hop router.
• preference—Specifies the preference value, a.k.a administrative distance, of an individual
static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example identifies the next-hop-ip and a preference value of 200.
console(config)#ip route 192.168.10.10 255.255.255.0 192.168.20.1
200
ip route distance
Use the ip route distance command in Global Configuration mode to set the default distance
(preference) for static routes. Lower route preference values are preferred when determining the
best route. The ip route and ip route default commands allow optional setting of the distance of
an individual static route. The default distance is used when no distance is specified in these