Dell PowerEdge M605 - Manual (Page 593)

IGMP Commands 597
User Guidelines
This command has no user guidelines.
Example
The following example configures 2 seconds as the Maximum Response Time inserted in
VLAN 15’s Group-Specific Queries.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp last-member-query-interval 20
ip igmp query-interval
Use the ip igmp query-interval command in Interface Configuration mode to configure the query
interval for the specified interface. The query interval determines how fast IGMP Host-Query
packets are transmitted on this interface.
Syntax
ip igmp query-interval seconds
no ip igmp query-interval
• seconds—Query interval. (Range: 1-3600)
Default Configuration
125 seconds is the default query interval value.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a 10-second query interval for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp query-interval 10
ip igmp query-max-response-time
Use the ip igmp query-max-response-time command in Internet Configuration mode to configure
the maximum response time interval for the specified interface. It is the maximum query response
time advertised in IGMPv2 queries on this interface. The time interval is specified in tenths of a
second.