Dell PowerEdge M605 - Manual (Page 121)

Management ACL Commands 85
Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to set conditions for the
management access list.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel number] [service service]
[priority priority]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-
id | port-channel number] [service service] [priority priority]
• ethernet interface-number—A valid Ethernet-routed port number.
• vlan vlan-id—A valid VLAN number.
• port-channel number—A valid routed port-channel number.
• ip-address—Source IP address.
• mask mask—Specifies the network mask of the source IP address.
• mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range: 0-32)
• service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
• priority priority—Priority for the rule. (Range: 1 - 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode