Dell PowerEdge M605 - Manual (Page 629)

IPv6 Routing Commands 633
Syntax
ipv6 mtu mtu
no ipv6 mtu
• mtu—Is the maximum transmission unit. (Range: 1280-1500)
Default Configuration
The default MTU is 1500.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the maximum transmission unit (MTU) size, in bytes, of IPv6
packets.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 mtu 1300
ipv6 nd dad attempts
Use the ipv6 nd dad attempts command in Interface Configuration mode to set the number of
duplicate address detection probes transmitted while doing neighbor discovery. Duplicate address
detection verifies that an IPv6 address on an interface is unique.
Syntax
ipv6 nd dad attempts attempts
no ipv6 nd dad attempts
• attempts—Probes transmitted. (Range: 0-600)
Default Configuration
1 is the default value for attempts.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.