Dell PowerEdge M605 - Manual (Page 344)

328 802.1x Commands
www
.dell.com | support.dell.com
802.1 Advanced Features
dot1x auth-not-req
Use the dot1x auth-not-req command in Interface Configuration (VLAN) mode to enable
unauthorized devices access to that VLAN. To disable access, use the no form of this command.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Default Configuration
User is authorized to access the VLAN.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN. The PVID of a trunk port
cannot be an unauthenticated VLAN. For a general port, the PVID can be the
unauthenticated VLAN (although only tagged packets would be accepted in the
unauthorized state.)
Example
The following example enables unauthorized users access to the VLAN.
console(config)#interface vlan 3
console(config-vlan3)#dot1x auth-not-req
dot1x guest-vlan
Use the dot1x guest-vlan command in Interface Configuration mode to define a guest VLAN. To
return to the default settings, use the no form of this command.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Default Configuration
No Guest VLAN enabled on interface.