Dell PowerEdge M605 - Manual (Page 515)

VLAN Commands 511
VLAN Commands
dvlan-tunnel ethertype
Use the dvlan-tunnel ethertype command in Global Configuration mode to configure the
ethertype for the specified interface.
To configure the EtherType on the specified interface to its default value, use the no form of this
command.
Syntax
dvlan-tunnel ethertype {802.1Q | vman | custom <0-65535>}
no dvlan-tunnel ethertype
• 802.1Q—Configures the EtherType as 0x8100.
• vman—Configures the EtherType as 0x88A8.
• custom—Custom configures the EtherType for the DVLAN tunnel. The value must be 0-
65535.
Default Configuration
The default for this command is 802.1Q.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
The following example displays configuring Double VLAN tunnel for vman EtherType.
console(config)#dvlan-tunnel ethertype vman