Dell PowerEdge M605 - Manual (Page 221)

IGMP Snooping Commands 191
console(config-vlan)#ip igmp snooping groupmembership-interval 2
520
ip igmp snooping maxresponse
This command sets the IGMP Maximum Response time on a particular VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query on an
interface because it did not receive a report for a particular group in that interface. This value must
be less than the IGMP Query Interval time value. The range is 1 to 3599 seconds. The no form of
this command sets the maximum response time on the VLAN to the default value.
Syntax
ip igmp snooping maxresponse vlan-id seconds
no ip igmp snooping maxresponse vlan-id
• vlan-id —Number assigned to the VLAN.
• seconds—IGMP Maximum response time in seconds. (Range: 1-3174)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
VLAN Configuration mode
User Guidelines
When using IGMP Snooping Querier, this parameter should be less than the value for the
IGMP Snooping Querier query interval.
Example
The following example sets the maximum response time to 60 seconds on VLAN 2.
console(config-vlan)#ip igmp snooping maxresponse 2 60
ip igmp snooping mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set on a particular
VLAN. This is the amount of time in seconds that a switch waits for a query to be received on an
interface before the interface is removed from the list of interfaces with multicast routers attached.
The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out (no expiration). The no
form of this command sets the Multicast Router Present Expiration time to 0. The time is set for a
particular VLAN.