Dell PowerEdge M605 - Manual (Page 58)

20 Command Groups
www
.dell.com | support.dell.com
class-map Defines a new DiffServ class of type match-all, match-any,
or match-access-group. For now, only match-all is available
in the CLI. GC
class-map rename Changes the name of a DiffServ class. GC
classofservice dotlp-mapping Maps an 802.1p priority to an internal traffic class for a
switch. GC and
IC
classofservice ip-dscp-mapping Maps an IP DSCP value to an internal traffic class. GC
classofservice trust Sets the class of service trust mode of an interface. GC and
IC
conform-color Specifies for each outcome, the only possible actions are
drop, set-cos-transmit, set-sec-cos-transmit, setdscp-
transmit, set-prec-transmit, or transmit PCMC
cos-queue min-bandwidth Specifies the minimum transmission bandwidth for each
interface queue. GC and
IC
cos-queue strict Activates the strict priority scheduler mode for each
specified queue. GC and
IC
diffserv Sets the DiffServ operational mode to active. GC
drop Use the drop policy-class-map configuration command to
specify that all packets for the associated traffic stream are
to be dropped at ingress. PCMC
mark cos Marks all packets for the associated traffic stream with the
specified class of service value in the priority field of the
802.1p header. PCMC
mark ip-dscp Marks all packets for the associated traffic stream with the
specified IP DSCP value. PCMC
mark ip-precedence Marks all packets for the associated traffic stream with the
specified IP precedence value. PCMC
match class-map Adds add to the specified class definition the set of match
conditions defined for another class. CMC
match cos Adds to the specified class definition a match condition for
the Class of Service value. CMC
match destination-address mac Adds to the specified class definition a match condition
based on the destination MAC address of a packet. CMC
match dstip Adds to the specified class definition a match condition
based on the destination IP address of a packet. CMC
Command Description Mode*