Dell PowerEdge M605 - Manual (Page 723)

OSPFv3 Commands 729
Example
The following example configures the retransmit interval of 20 seconds for the OSPF virtual
interface on the virtual interface identified by area 1 and its neighbor.
(config)#ipv6 router ospf
(config-rtr)#area 1 virtual-link 2 retransmit-interval 20
area virtual-link transmit-delay
Use the area virtual-link transmit-delay command in Router OSPFv3 Configuration mode to
configure the transmit delay for the OSPF virtual interface on the virtual interface identified by
areaid and neighbor.
Syntax
area areaid virtual-link neighbor transmit-delay seconds
no area areaid virtual-link neighbor transmit-delay
• areaid—Valid OSPFv3 area identifier.
• neighbor—Router ID of neighbor.
• seconds—Transmit delay interval. (Range: 0-3600)
Default Configuration
1 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a 20-second transmit delay for the OSPF virtual interface
on the virtual interface identified by area 1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 transmit-delay 20
default-information originate
Use the default-information originate command in Router OSPFv3 Configuration mode to
control the advertisement of default routes. Use the no form of the command to return the default
route advertisement settings to the default value.