Dell PowerEdge M605 - Manual (Page 653)

Multicast Commands 659
Multicast Commands
ip mcast boundary
Use the ip mcast boundary command in Interface Configuration mode to add an administrative
scope multicast boundary specified by groupipaddr and mask for which this multicast
administrative boundary is applicable. groupipaddr is a group IP address and mask is a group IP
mask.
Syntax
ip mcast boundary groupipaddr mask
no ip mcast boundary groupipaddr mask
• groupipaddr—IP address of multicast group. Valid range is 239.0.0.0 to 239.255.255.255.
• mask—IP mask of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255