Dell PowerEdge M605 - Manual (Page 352)

338 Configuration and Image File Commands
www
.dell.com | support.dell.com
Storing the Running or Startup Configuration on a Server
Use the copy running-config destination-url command to copy the current configuration file
to a network server using TFTP. Use the copy startup-config destination-url command to
copy the startup configuration file to a network server.
The configuration file copy can serve as a backup copy.
Saving the Running Configuration to the Startup Configuration
Use the copy running-config startup-config command to copy the running configuration to
the startup configuration.
Backing up the Running Configuration or Startup Configuration to the Backup Configuration
Use the copy running-config backup-config command to back up the running configuration
to the backup configuration file. Use the copy startup-config backup-config command to
back up the startup configuration to the backup configuration file.
Copying to a Unit on the Stack Using unit
The copy command can be used to copy an image to another unit. This means that a copy
command allows the management node to distribute its existing code to other nodes. The
command syntax is copy image unit {all | <1-12>}
NOTE: The copy command can accept the unit {all | <1-12>} only as the destination-url. In this case, only
image can be the source-url.
NOTE: Note that the copy image unit all command does not copy the active image to the backup image on
the management unit, just the stack units.
The copy command can not:
• Either download code from tftp, for example, to the stack units directly, or
• Copy code from one stack unit to another stack unit.
For copying to all units simultaneously, use the keyword all.
Example
The following example copies a system image named file1 from the TFTP server with an IP
address of 172.16.101.101 to a non active image file in flash memory.
console#copy tftp://172.16.101.101/pc62xxr1v0.stk image
Mode........................................... TFTP
Set TFTP Server IP............................. 172.16.101.101
TFTP Path...................................... ./
TFTP Filename.................................. pc62xxr1v0.stk
Data Type...................................... Code