Dell PowerEdge M605 - Manual (Page 532)

528 VLAN Commands
www
.dell.com | support.dell.com
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to enables port ingress filtering on 1/g8.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport general ingress-filtering
disable
switchport general pvid
Use the switchport general pvid command in Interface Configuration mode to configure the Port
VLAN ID (PVID) when the interface is in general mode. Use the switchport mode general
command to set the VLAN membership mode of a port to "general." To configure the default value,
use the no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
• vlan-id—PVID. The VLAN ID may belong to a non-existent VLAN.
Default Configuration
The default value for the vlan-id parameter is 1 when the VLAN is enabled. Otherwise, the
value is 4093.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.