Dell PowerEdge M605 - Manual (Page 609)

IP Routing Commands 613
IP Routing Commands
encapsulation
Use the encapsulation command in Interface Configuration mode to configure the link layer
encapsulation type for the packet. Routed frames are always ethernet encapsulated when a frame is
routed to a VLAN.
Syntax
encapsulation {ethernet | snap}
• ethernet—Specifies Ethernet encapsulation.
• snap—Specifies SNAP encapsulation.
Default Configuration
Ethernet encapsulation is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example applies SNAP encapsulation for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#encapsulation snap
ip address
Use the ip address command in Interface Configuration mode to configure an IP address on an
interface. Also use this command to configure one or more secondary IP addresses on the interface.
This command changes the label IP address in the show IP interface.