Dell PowerEdge M605 - Manual (Page 383)

QoS Commands 371
• ipmask—Specifies a valid IP address bit mask. Note that although this IP address bit
mask is similar to a subnet mask, it does not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition for the specified IP address and
address bit mask.
console(config-classmap)#match srcip 10.240.1.1 10.240.0.0
match srcl4port
Use the match srcl4port command in Class-Map Configuration mode to add to the specified class
definition a match condition based on the source layer 4 port of a packet using a single keyword or
a numeric notation.
Syntax
match srcl4port {portkey|port-number}
• portkey—Specifies one of the supported port name keywords. A match condition is
specified by one layer 4 port number. The currently supported values are: domain, echo,
ftp, ftpdata, http, smtp,snmp, telnet, tftp, and www.
• port-number—Specifies a layer 4 port number (Range: 0–65535).
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
None