Dell PowerEdge M605 - Manual (Page 794)

804 Tunnel Interface Commands
www
.dell.com | support.dell.com
Syntax
show interfaces tunnel [tunnel-id ]
• tunnel-id—Tunnel identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel and to all tunnel
interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId Interface TunnelMode SourceAddress DestinationAddress
-------- --------- ---------- ------------- ----------------
1 tunnel 1 IPv6OVER4 10.254.25.14 10.254.25.10
2 tunnel 2 IPv6OVER4 10.254.20.10
tunnel destination
Use the tunnel destination command in Interface Configuration mode to specify the destination
transport address of the tunnel.
Syntax
tunnel destination ipv4addr
no tunnel destination
• ipv4addr—Valid ipv4 address.