Dell PowerEdge M605 - Manual (Page 225)

IGMP Snooping Querier Commands 197
ip igmp snooping querier query-interval
This command sets the IGMP Querier Query Interval time, which is the amount of time in
seconds that the switch waits before sending another general query. The no form of this command
sets the IGMP Querier Query Interval time to its default value.
Syntax
ip igmp snooping querier query-interval seconds
no ip igmp snooping querier query-interval
• seconds—Amount of time in seconds that the switch waits before sending another
general query. (Range: 1-1800)
Default Configuration
The query interval default is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
The value of this parameter should be larger than the IGMP Snooping Max Response Time.
Example
The following example sets the query interval to 1800:
console(config)#ip igmp snooping querier query_interval 1800
ip igmp snooping querier timer expiry
This command sets the IGMP Querier timer expiration period which is the time period that the
switch remains in Non-Querier mode after it has discovered that there is a Multicast Querier in the
network. The no form of this command sets the IGMP Querier timer expiration period to its
default value.
Syntax
ip igmp snooping querier timer expiry seconds
no ip igmp snooping querier timer expiry
• seconds—The time in seconds that the switch remains in Non-Querier mode after it has
discovered that there is a multicast querier in the network
Default Configuration
The query interval default is 60 seconds.