Dell PowerEdge M605 - Manual (Page 144)

110 Address Table Commands
www
.dell.com | support.dell.com
Example
The following example adds a permanent static MAC-layer station source address
3aa2.64b3.a245 to the bridge table.
console(config-if-vlan1)#bridge address 3AA2.64B3.A245 ethernet
1/g8 permanent
bridge aging-time
Use the bridge aging-time command in Global Configuration mode to set the aging time of the
address. To restore the default, use the no form of the bridge aging-time command.
Syntax
bridge aging-time seconds
no bridge aging-time
• seconds—Time is the number of seconds. (Range: 10 - 1000000 seconds)
Default Configuration
300 seconds
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In this example the bridge aging time is set to 400.
console(config)#bridge aging-time 400
bridge multicast address
Use the bridge multicast address command in Interface Configuration mode to register MAC-layer
Multicast addresses to the bridge table and to add ports to the group statically. To deregister the
MAC address, use the no form of the bridge multicast address command.
Syntax
bridge multicast address {mac-multicast-address|ip-multicast-address}
bridge multicast address {mac-multicast-address|ip-multicast-address} [add|remove]
{ethernet interface-list|port-channel port-channel-number-list}