Dell PowerEdge M605 - Manual (Page 442)

434 SNMP Commands
www
.dell.com | support.dell.com
snmp-server group
Use the snmp-server group command in Global Configuration mode to configure a new Simple
Management Protocol (SNMP) group or a table that maps SNMP users to SNMP views. To remove
a specified SNMP group, use the no form of this command.
Syntax
snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } [ notify notifyview ] }
[ context contextname ] [ read readview ] [ write writeview ]
no snmp-server group groupname { v1 | v2 | v3 { noauth | auth | priv } } [ context
contextname ]
• groupname—Specifies the name of the group. (Range: 1-30 characters.)
• v1—Indicates the SNMP Version 1 security model.
• v2—Indicates the SNMP Version 2 security model.
• v3—Indicates the SNMP Version 3 security model.
• noauth—Indicates no authentication of a packet. Applicable only to the SNMP Version 3
security model.
• auth—Indicates authentication of a packet without encrypting it. Applicable only to the
SNMP Version 3 security model.
• priv—Indicates authentication of a packet with encryption. Applicable only to the SNMP
Version 3 security model.
• noauth—Specifies no authentication of a packet.
• readview —A string that is the name of the view that enables the you to view only the
contents of the agent. If unspecified, all the objects except for the community-table and
SNMPv3 user and access tables are available. (Range: 1-30 characters.)
• writeview —A string that is the name of the view that enables the user to enter data and
configure the contents of the agent. If unspecified, nothing is defined for the write view.
(Range: 1-30 characters.)
• notifyview —Defines a string that is the name of the view that enables specifying an
inform or a trap. If unspecified, nothing is defined for the notify view. (Range: 1-30
characters.)
Default Configuration
No group entry exists. There will be some default groups for Read/Write/Super users. These
groups cannot be deleted or modified by the user. This command is used only to configure the
user-defined groups.
Command Mode
Global Configuration Mode