Dell PowerEdge M605 - Manual (Page 766)

774 PIM-SM Commands
www
.dell.com | support.dell.com
Command Mode
Global Configuration (VLAN) mode
User Guidelines
Use this command to control the number of register messages that the designated router
(DR) will allow for each (S, G) entry.
When the value is set to zero, the PIM RP router joins the shortest path tree immediately
after the first Register packet arrives from DR.
Example
console(config)#ip pimsm register-rate-limit 1000
ip pimsm spt-threshold
Use the ip pimsm spt-threshold command in Global Configuration mode to configure the Data
Threshold rate for the last-hop (or leaf) router to switch to the shortest path. The rate is specified
in kilobits per second.
Syntax
ip pimsm spt-threshold threshold
no ip pimsm spt-threshold
• threshold—Threshold rate. (Range: 0-2000 kilobits/sec)
Default Configuration
50 kilobits/sec is the default rate.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a threshold rate of 100 kilobits/sec.
console(config)#ip pimsm spt-threshold 100
ip pimsm staticrp
Use the ip pimsm staticrp command in Global Configuration mode to create RP IP address for the
PIM-SM router.