Dell PowerEdge M605 - Manual (Page 645)

IPv6 Routing Commands 649
Example
The following example displays a summary of the routing table.
console#show ipv6 route summary
IPv6 Routing Table Summary - 0 entries
Connected Routes............................... 0
Static Routes.................................. 0
OSPF Routes.................................... 0
Intra Area Routes............................ 0
Inter Area Routes............................ 0
External Type-1 Routes....................... 0
External Type-2 Routes....................... 0
Total routes................................... 0
Number of Prefixes:
show ipv6 traffic
Use the show ipv6 traffic command in User EXEC mode to show traffic and statistics for IPv6 and
ICMPv6.
Syntax
show ipv6 traffic [vlan vlan-id | tunnel tunnel-id | loopback loopback-id]
• vlan-id—Valid VLAN ID, shows information about traffic on a specific interface or,
without the optional parameter, shows information about traffic on all interfaces.
• tunnel—Tunnel identifier. (Range: 0-7)
• loopback—Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.