Dell PowerEdge M605 - Manual (Page 382)

370 QoS Commands
www
.dell.com | support.dell.com
Example
The following example displays adding a match condition based on the "ip" protocol name
keyword.
console(config-classmap)#match protocol ip
match source-address mac
Use the match source-address mac command in Class-Map Configuration mode to add to the
specified class definition a match condition based on the source MAC address of the packet.
Syntax
match source-address mac address macmask
• macaddr—Specifies any valid layer 2 MAC address formatted as six two-digit
hexadecimal numbers separated by colons.
• macmask—Specifies a layer 2 MAC address bit mask formatted as six two-digit
hexadecimal numbers separated by colons. This bit mask does not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match condition based on the
source MAC address of the packet.
console(config-classmap)# match source-address mac
10:10:10:10:10:10 11:11:11:11:11:11
match srcip
Use the match srcip command in Class-Map Configuration mode to add to the specified class
definition a match condition based on the source IP address of a packet.
Syntax
match srcip ipaddr ipmask
• ipaddr—Specifies a valid IP address.