Dell PowerEdge M605 - Manual (Page 747)

OSPFv3 Commands 753
Example
The following example displays brief ospf interface information.
console#show ipv6 ospf interface brief
Hello Dead Retrax LSA
Admin Router Int. Int. Int. Retrax Ack
Interface Mode Area ID Prior. Cost Val. Val. Val. Delay Intval
--------- -------- -------- ------ ----- ----- ----- ------ ------ ------
show ipv6 ospf interface stats
Use the show ipv6 ospf interface stats command in User EXEC mode to display the statistics for a
specific interface. The command only displays information if OSPF is enabled.
Syntax
show ipv6 ospf interface stats vlan vlan-id
• vlan-id—Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the interface statistics for VLAN 5.
console>show ipv6 ospf interface stats vlan 5
OSPFv3 Area ID................................. 0.0.0.1
Spf Runs....................................... 265
Area Border Router Count....................... 1
AS Border Router Count......................... 0
Area LSA Count................................. 6
IPv6 Address...................................
FE80::202:BCFF:FE00:3146/1283FFE::2/64
OSPF Interface Events.......................... 53