Dell PowerEdge M605 - Manual (Page 70)

32 Command Groups
www
.dell.com | support.dell.com
Layer 3 Commands
ARP Commands
DHCP and BOOTP Relay Commands
Command Description Mode*
arp Creates an Address Resolution Protocol (ARP) entry. GC
arp cachesize Configures the maximum number of entries in the ARP
cache. GC
arp dynamicrenew Enables the ARP component to automatically renew
dynamic ARP entries when they age out. GC
arp purge Causes the specified IP address to be removed from the
ARP cache. PE
arp resptime Configures the ARP request response timeout. GC
arp retries Configures the ARP count of maximum request for retries. GC
arp timeout Configures the ARP entry age-out time. GC
clear arp-cache Removes all ARP entries of type dynamic from the ARP
cache. PE
ip proxy-arp Enables proxy ARP on a router interface. IC
show arp Displays the Address Resolution Protocol (ARP) cache. PE
show arp brief Displays the brief Address Resolution Protocol (ARP) table
information. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
bootpdhcprelay cidridoptmode Enables the circuit ID option and remote agent ID mode
for BootP/DHCP Relay on the system. GC
bootpdhcprelay enable Enables the forwarding of relay requests for BootP/DHCP
Relay on the system. GC
bootpdhcprelay maxhopcount Configures the maximum allowable relay agent hops for
BootP/DHCP Relay on the system. GC
bootpdhcprelay minwaittime Configures the minimum wait time in seconds for
BootP/DHCP Relay on the system. GC
bootpdhcprelay serverip Configures the server IP address for BootP/DHCP Relay on
the system. GC