Dell PowerEdge M605 - Manual (Page 146)

112 Address Table Commands
www
.dell.com | support.dell.com
no bridge multicast filtering
Default Configuration
Disabled. All Multicast addresses are flooded to all ports of the relevant VLAN.
Command Mode
Global Configuration mode
User Guidelines
If switches exist on the VLAN, do not change the unregistered Multicast addresses’ state to
drop on the switch ports.
If switches exist on the VLAN and IGMP snooping is not enabled, use the bridge multicast
forward-all command to enable forwarding all Multicast packets to the Multicast routers.
Example
In this example, bridge Multicast filtering is enabled.
console(config)#bridge multicast filtering
bridge multicast forbidden address
Use the bridge multicast forbidden address command in Interface Configuration mode to
forbid adding a specific Multicast address to specific ports. To return to the system default,
use the no form of this command. If routers exist on the VLAN, do not change the
unregistered multicast addresses state to drop on the routers ports.
Syntax
bridge multicast forbidden address {mac-multicast-address|ip-multicast-address} {add |
remove} {ethernet interface-list|port-channel port-channel-number-list}
no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address}
• add—Adds ports to the group.
• remove—Removes ports from the group.
• mac-multicast-address—MAC Multicast address.
• ip- multicast-address—IP Multicast address.
• interface-list—Separate nonconsecutive valid Ethernet ports with a comma and no
spaces; use a hyphen to designate a range of ports.
• port-channel-number-list—Separate nonconsecutive valid port-channels with a comma
and no spaces; use a hyphen to designate a range of port-channels.