Dell PowerEdge M605 - Manual (Page 679)

OSPF Commands 685
Default Configuration
10 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a 50-second wait interval.
console(config-router)#area 10 virtual-link 192.168.2.2 hello-
interval 50
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPF Configuration mode to
configure the retransmit interval for the OSPF virtual interface on the virtual interface identified
by the area ID and neighbor ID. Use the no form of the command to return the retransmit interval
to the default value.
Syntax
area area-id virtual-link neighbor-id retransmit-interval seconds
no area area-id virtual-link neighbor-id retransmit-interval
• area-id—Identifies the OSPF area to configure. (Range: IP address or or decimal from 0-
4294967295)
• neighbor-id—Identifies the Router ID of the neighbor.
• seconds—The number of seconds to wait between retransmitting LSAs if no
acknowledgement is received. (Range: 1-3600)
Default Configuration
5 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a 500-second retransmit wait interval.