Dell PowerEdge M605 - Manual (Page 787)

Routing Information Protocol (RIP) Commands 795
User Guidelines
This command has no user guidelines.
Example
The following example allows no RIP control packets to be received by VLAN 11.
console(config-if-vlan11)#ip rip receive version none
ip rip send version
Use the ip rip sent version command in Interface Configuration mode to configure the interface to
allow RIP control packets of the specified version to be sent. Use the no form of the command to
return the version to the default value.
Syntax
ip rip send version {rip1 | rip1c | rip2 | none}
no ip rip send version
• rip1—Send RIP version 1 formatted packets.
• rip1c—Send RIP version 1 compatibility mode, which sends RIP version 2 formatted
packets via broadcast.
• rip2—Send RIP version 2 using multicast.
• none—Do not allow any RIP control packets to be sent.
Default Configuration
RIP2 is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example allows no RIP control packets to be sent by VLAN 11.
console(config-if-vlan11)#ip rip send version none
redistribute
This command configures RIP protocol to redistribute routes from the specified source
protocol/routers. If the source protocol is OSPF, there are five possible match options.
Syntax