Show ip ospf database – Dell PowerEdge M605 User Manual
Page 699
OSPF Commands
705
User Guidelines
This command has no user guidelines.
Example
console#show ip ospf asbr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- ---------- ---- -------- ----------- -----------
INTRA 1.1.1.1 1 0.0.0.1 10.1.12.1 vlan10
INTRA 4.4.4.4 10 0.0.0.1 10.1.24.4 vlan12
show ip ospf database
Use the show ip ospf database command in Privileged EXEC mode to display information about
the link state database when OSPF is enabled. If parameters are entered, the command displays the
LSA headers. Use the optional parameters to specify the type of link state advertisements to
display.
Syntax
show ip ospf [
router | summary}][ls-id] [adv-router [ip-address] | self-originate]
•
area-id—Identifies a specific OSPF area for which link state database information will be
displayed.
•
asbr-summary—Display the autonomous system boundary router (ASBR) summary
LSAs.
•
external—Display the external LSAs.
•
network—Display the network LSAs.
•
nssa-external—Display NSSA external LSAs.
•
router—Display router LSAs.
•
summary—Display the LSA database summary information.
•
ls-id—Specifies the link state ID (LSID). (Range: IP address or an integer in the range of
0-4294967295)
•
adv-router—Display the LSAs that are restricted by the advertising router. To specify a
router, enter the IP address of the router.
•
self-originate—Display the LSAs in that are self-originated.