Bio-Rad Firmware & Software Updates - Manual (Page 67)

Plates
54
Open the Experiment Settings window to view or change the list of Targets and Samples
(Figure 34) or to set the gene expression analysis sample group to be analyzed if Biological
Set Names have been added to the wells.
• Targets. A list of target names for each PCR reaction, such as a genes or sequences of
interest. Click the Reference column to assign reference genes in a run
• Samples. A list of sample names that indicate the source of the target, such as a sample
taken at 1 hr (1 hr) or taken from a specific individual (“mouse1”). Click the Control
column to assign the control condition for a run
Figure 34 shows the Targets tab with the analysis settings shown.
Figure 34. Targets tab in Experiment Settings window.
Figure 35 shows the Samples Tab with the Analysis Settings shown.
Figure 35. Samples tab in Experiment Settings window.
To adjust the lists in these tabs, use the following functions:
• Add a target or sample name by typing a name in the New box and clicking Add
• Remove a target or sample name from the list by clicking the Select to Remove box
for that row and then clicking the Remove checked item(s) button