Bio-Rad Firmware & Software Updates - Manual (Page 66)

CFX96 Touch, CFX96 Touch Deep Well, CFX Connect, and CFX384 Touch Systems Instruction Manual
53
NOTE: Well contents can also be copied and pasted into other wells. To do this,
highlight the well that is to be copied (only one well can be copied at a time), right-
click, and select Copy Well. Highlight the wells into which content is be pasted and
select Paste Well. Depress and hold the control key to select non-contiguous wells
to paste content into.
Experiment Settings Window
To open the Experiment Settings window, perform one of these options:
• In the Plate Editor, click the Experiment Settings button
• While analyzing data in the Data Analysis window, click the Experiment Settings
button in the Gene Expression tab
Click the Dilution Series button to enter a dilution series
for the concentration of Standard samples, and load a
standard curve.
Enter the Starting Concentration for the dilution series,
the Replicates from (starting replicate number) and to
(ending replicate number), and the Dilution Factor
(amount to change the concentration with each replicate
group). Select Increasing for a dilution series that
increases or select Decreasing for a dilution series that
decreases. Finally, select the fluorophore used for the
dilution series from the pull-down menu and click Apply
Check the Well Notes box on the bottom to show this
pane. Enter notes about one or more wells by selecting
the wells and typing the notes in the pull-down menu. Any
notes you add appear in the spreadsheet on the
Quantification Data tab
Check the Biological Set Name box on the bottom to
show this pane. Enter biological set information about one
or more wells by selecting the wells and typing a
biological set name in the pull-down menu. Entering
Biological Set Name information enables sample
analysis in one of four configurations defined by the
Biological Set Analysis Options
Click the Experiment Settings button to open the
Experiment Settings window to manage the lists of
Targets and Samples and to set up a gene expression run
Click the Clear Replicate # button to clear the replicate
numbers in the selected wells
Click the Clear Wells button to permanently remove all
content in the selected wells
Table 17. Options for loading the plate and wells in the Plate Editor. (continued)
Option Function