Rockwell Automation 1761 MicroLogix 1000 Programmable Controllers - Manual (Page 409)

Index
I–11
Masked Comparison for Equal (MEQ),
7-5
Not Equal (NEQ), 7-3
overview, 7-2
indexed word addresses, 7-2
connecting the system, 3-1
AIC+, 3-9
DF1 fullĆduplex protocol, 3-2
DHĆ485 network, 3-5
contact protection methods, 1-8
contacting AllenĆBradley for assistance, P-6
contactors (bulletin 100), surge suppressors
for, 1-10
Contents of this Manual, P-3
control file (R6:), 4-6
controller
determining faults, 14-2
dimensions, A-9
fault messages, 14-7
features, 1-3
grounding, 2-2
installation, 1-1
mounting, 1-14
mounting template, A-9
operating cycle, 4-3
replacement parts, A-10
spacing, 1-14
specifications, A-2
status file, B-1
troubleshooting, 14-2
types, 1-3, A-2
16 I/O, 1-3
32 I/O, 1-3
wiring
for highĆspeed counter operation, 2-24
recommendations, 2-4
wire type, 2-4
controller faults, 14-2
controller operation, normal, 14-2
controllers, analog, 1-3
Convert from BCD (FRD), 9-5
example, 9-6
execution times, 9-5
instruction parameters, C-6
updates to arithmetic status bits, 9-5
valid addressing modes, C-6
valid file types, C-6
Convert to BCD (TOD), 9-3
changes to the math register, 9-3
example, 9-4
execution times, 9-3
instruction parameters, C-13
updates to arithmetic status bits, 9-3
valid addressing modes, C-13
valid file types, C-13
converting analog data, 5-5
Converting Analog Input Data, 5-5, 5-6
COP, Copy File, 9-10
Copy File (COP), 9-10
execution times, 9-10
instruction parameters, C-4
using, 9-11
entering parameters, 9-11
valid addressing modes, C-4
valid file types, C-4
Count Down (CTD), 6-19
execution times, 6-19
instruction parameters, C-5
using status bits, 6-19
valid addressing modes, C-5
valid file types, C-5
Count Up (CTU), 6-18
execution times, 6-18
instruction parameters, C-5
using status bits, 6-18
valid addressing modes, C-5
valid file types, C-5
counter file (C5:), 4-6
counter instructions
Count Down (CTD), 6-19
Count Up (CTU), 6-18
in the paper drilling machine application
example, 7-8