Northern Connectors Harting HAN Industrial Rectangular Connectors - Manual (Page 197)

Han
Q
13
.
08
Features
Current carrying capacity
The current carrying capacity of the connectors is limited by the
thermal load capability of the contact element material including
the connections and the insulating parts. The derating curve
is therefore valid for currents which flow constantly (non-inter-
mittent) through each contact element of the connector evenly,
without exceeding the allowed maximum temperature.
Measuring and testing techniques according to
DIN EN 60 512-5
Operating current
Ambient temperature
Wire gauge: ➀ 2.5 mm²
➁ 4 mm²
➂ 6 mm²
➃ 10 mm²
Technical characteristics
Specifications DIN EN 60 664-1
DIN EN 61 984
Approvals
Inserts
Number of contacts 2 + PE
Electrical data
acc. to EN 61 984 40 A 830 V 6 kV 3
Rated current 40 A
Rated voltage 830 V
Rated impulse voltage 6 kV
Pollution degree 3
Rated voltage
acc. to UL/CSA 600 V
Insulation resistance ≥ 10 10 Ω
Material polycarbonate
Limiting temperatures -40 °C ... 125 °C
Flammability acc. to UL 94 V 0
Mechanical working life
- mating cycles ≥ 500
Contacts
Material copper alloy
Surface
- hard-silver plated 3 µm Ag
Contact resistance ≤ 1 mΩ
Axial screw termination
- mm² 2.5 ... 10 mm²
- AWG 14 ... 8
Tightening torque 1.8 Nm
Stripping length 8 mm +1
Hoods/Housings
Selection of hoods/housings see chapter 31
Plastic hoods/housings
Material polycarbonate
Flammability acc. to UL 94 V 0
Degree of protection acc. to DIN EN 60 529
for coupled connector IP 67
Hoods/Housings, metal
Material zinc die-cast
Degree of protection acc. to DIN EN 60 529
for coupled connector IP 44
IP 67 is achieved with seal
screw
"https://b2b.harting.com/ebusiness/en/
09 20 000 9918
"
Accessories
Cable clamps chapter 95
Sealing screw chapter 95
• Compact designed connector for high current
ratings with axial screw terminal
• 16 coding options
• For hoods/housings size Han ® 3 A
• Finger protected male and female contacts
• For high voltages please use heat shrink tube
(included in delivery range)
Attention
• By using in Han ® 3 A HPR hoods/housings the sealing on the
insert has to be removed.
• For termination please use only hexagonal screw driver with
wrench size SW 2.
• If PE contact is not used:
Please screw the PE contact maximal on both sides clockwise
with a hexagonal screwdriver, wrench size SW 2.
Han ® Q 2/0 Axial screw High voltage