Kinze Ag Leader Integra - Manual (Page 79)

63
S
ETUP
F
IELD
O
PERATIONS
Topography
The display allows you to record points that can be used to make a reference layer
that is relative to the elevation throughout the field. This requires that you have an
RTK GPS signal to collect the accurate elevation data.
You can also import data from mapping software such as SMS Advanced via
.agsetup files.
Pressing the Topography button takes you to the Topography screen which allows
user to setup Topography functionality.
Topography screen
New Survey button - press to create a new elevation
survey
Add to Selected button - press to add to an
elevation survey
Minus (-) button - press to delete a topographical
survey
Enable checkbox - press to turn elevation reference
layer on/off (Enable checkbox functions the same as
Topography checkbox in Map Options screen -
shown below.)
Set Active - select the desired survey from list and
use button to set as active.
This topography layer can be turned on/off as a
reference layer during any operation using Enable
checkbox on Topography screen (shown above) or
using the Topography checkbox on the Map Options
screen (see
“Map Legend tab” on page 55 ).
This can provide you with valuable information in
regards to the highs and lows of a field when you
may not be able to visually tell with the naked eye.
Surveying and Tiling operations will probably benefit
the most with respect of where to place the mains
and laterals in a field.
Boundary
Field
Headlands
Topography
Topography
Elevation Surveys
West 160_20130820
Tue Sep 2 08:00:00 2013
New
Survey
Add to
Selected
Enable Set Active
Map Options
Load
Reference
Data Guidance Boundary Marker
Reference Rx Tile Grid
Topography
Clear Map