Seed monitor thresholds, Seedcommand map screen examples, Onitor – Kinze Ag Leader Integra User Manual
Page 210: Hresholds, Ommand, Creen, Xamples
194
Firmware Version 5.2
S
EED
M
ONITOR
T
HRESHOLDS
Press: Map button > Settings button > Seed Monitor tab > Thresholds button
Adjust Seed Tube Monitor Module alarm thresholds.
S
EED
C
OMMAND
M
AP
S
CREEN
E
XAMPLES
Below is an example of a SeedCommand operating configuration. The screen shows a Seed Tube
Monitor Module (STMM), with Row Shutoff and three Stepper Motor Drives.
• (A) Mapping Toolbox
• (B) Product Control Toolbox
• (C) Section Indicators
Shown at the bottom of the Product Control
Toolbox.
• (D) Meter RPM button
Appears at the bottom right hand side of the
Map screen, displays the number of
hydraulic or stepper seed motors and their
speed, shown in Revolutions Per Minute
(RPM). Pressing the Meter RPM button
summons the Seed Rate Planter Control
screen, to calibrate and prime the seed
meters. See
“Calibrating Seed Rate Meters”
• (E) AutoSwath
The Seed Tube Monitor Module provides population monitoring for DICKEY-john® seed tube sensors
used on several different brands of planters. Configure the Seed Tube Monitor Module in the following
order.
Settings
Seed Monitor
Thresholds
5 in
3 in
Seed Monitor Thresholds
Corn
Poor Spacing Threshold
Double Seed Threshold
38.4
ac
0.67 ac
5.0
mph
29000
30000
sds/ac
30000
30000
Flow:
Applied:
Area:
7920 sds/min
19602.0 sds
1
2
Population: 32000 sds/ac
Spacing: 6.7 in
Planter Drives (rpm)
Settings
1
2
3
32
38
37
Down Force
Gauge Wheel:
197 lb
Down Force:
197 lb
2
4
6
8
10
12
14
16
18
20
22
24
80 %
60 %