Calibrate pressure, Fence row nozzle indicators, Ence – Kinze Ag Leader Integra User Manual
Page 240: Ozzle, Ndicators
224
Firmware Version 5.2
• Response Threshold
Determines where the control channel switches between using Valve Response 1 and Valve Response 2
speed settings. The default setting is 3. Leaving all other valve control settings at the default value and
making a small adjustment to this setting is usually all that is required to fine-tune system performance.
- Decreasing this value will have the overall effect of speeding up servo valve response.
- Increasing this value will have the overall effect of slowing servo valve response.
Calibrate Pressure
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > select
your specific configuration > Setup (wrench) button > Calibrate Pressure button
Choose Main, Agitation or Aux from drop-down box. Press
to continue.
Press
to enter pressure value as a set point or press Reset to Default button. Press
to
continue.
Press
to enter voltage/pressure ratio. Press
to continue.
Press
to finish process.
.F
ENCE
R
OW
N
OZZLE
I
NDICATORS
Control fence row nozzles through the DirectCommand system by mapping the switches in Auxiliary
Input Settings. Fence row nozzles can be mapped to any switch.
or
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > select
your specific configuration > Setup (wrench) button > Auxiliary Input button > Assign button > Left Fence
Row or Right Fence Row. For more information on Auxiliary Input Settings, see
.
Configuration
Select Your Specific
Configuration
Calibrate Pressure
Configuration
Select Your Specific
Configuration
Auxiliary Input
Assign
Left Fence Row
Right Fence Row