Kinze Ag Leader Integra - Manual (Page 265)

249
A
PPLICATION
I
NJECTION
A PPLICATION
I
NJECTION
DirectCommand interfaces with the Raven SCS Sidekick™ for complete control over chemical injection
applications. The display can support up to four Raven SCS Sidekick™ injection pumps plus a liquid
carrier.
C
REATE
C
ONFIGURATION
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > Add
(+) button > Application button
A wizard will guide you through the process of selecting or creating a vehicle, implement and controllers.
Your Operating Configuration will then be viewable when you start a new Field Operation with the Field
Operation Wizard. For more information:
See “Create Configuration” on page 217.
S
ETUP
C
ONFIGURATION
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > 2 tab >Controller Settings button
The Controller Settings screen appears.
Pump Calibration
• Factory Calibration
This number is found on the tag of the Digital Pump
Speed Sensor. This tag number represents pulses per
10 fluid ounces. Divide the tag number by 10 and enter
this number. Once entered, this number should not be
changed.
• Perform Calibration
Press the Perform Calibration button to begin the
calibration procedure for the Direct Injection pump. The
pump will not run until this calibration has been
performed. For more information, see
“Calibrating an
Injection Pump” on page 250 .
Rate Response Warning
• Error Threshold
The user-defined percentage of actual rate error allowed before an alarm sounds.
Configuration Application
Configuration
Select Your Specific
Configuration
Controller Settings
Controller Settings
Pump Calibration
Factory
Calibration
11 pls/fl oz Perform
Calibration
11 pls/fl oz
Rate Response Warning
Error
Threshold
Error Delay 5 s
30 %
Flow Monitor Warning
25 %
Error
Threshold
Enable Warning
Active Calibration