Edgevac, Kinze sensor configuration, Muxbus sensor detection – Kinze Ag Leader Integra User Manual
Page 221: Kinze sensor configuration muxbus sensor detection, Information, see, Kinze p
205
P
LANTING
KINZE P
LANTER
M
ONITOR
M
ODULE
• EdgeVac Sensors
Use
/
to enter the number of EdgeVac® sensors on the planter. Calibrate EdgeVac sensors
once a year. To start process, press the Calibrate button.
• Tank Pressure
Check the box only if the planter is equipped with tank pressure sensor. Calibrate the sensor once a year.
To start process, press Calibrate button.
EdgeVac
Use /
to enter the number of EdgeVac® sensors.
Calibrate EdgeVac sensors once a year. To start process, press Calibrate button. For more information,
see
“KINZE EdgeVac Calibration” on page
.
KINZE Sensor Configuration
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Seed Monitor button > Sensor Configuration button
The Sensor Configuration screen is for system
maintenance of the KINZE Population Monitor.
• The Install button installs a row sensor.
• Remove button
Removes the highlighted sensor of any type.
• Revive button
Allows the display to reattempt communication with the
highlighted sensor of any type.
• Ignore button
Tells the display to cease communications with a row
sensor.
• View button
Shows the Sensor Information screen. For more information, see
.
Note: After initial configuration of the KINZE Planter Monitor, complete the Sensor Muxbus Detection process.
For more information, see
“Muxbus Sensor Detection” on page
Muxbus Sensor Detection
After initial configuration of the KINZE Planter Monitor, complete the Sensor Muxbus Detection process.
This process allows the muxbus to detect each sensor on the planter. In order for the display to show the
correct Planter Monitor information, complete the detection process for each muxbus sensor.
Note: Be sure that all sensors are unplugged before beginning the process. If any sensors are plugged in,
the Muxbus Detection process will abort. If this occurs, unplug all sensors and retry procedure.
Configuration
Select Your Specific
Configuration
Seed Monitor
Sensor Configuration
Rear Section
Row 1 OK
Row 2 OK
Row 3 OK
Row 4 OK
Row 5 OK
Row 6 OK
Row 7 OK
Install
Remove
Revive
Ignore
View
Item Status
Sensor Configuration
Row 8 OK
Row 9 OK
Row 10 OK