Kinze Ag Leader Integra - Manual (Page 340)

324 Firmware Version 5.2
M
AP
S
CREEN FOR
CLAAS Q
UANTIMETER
Once an operating configuration is
created for a CLAAS Quantimeter
harvest configuration, and a field
operation configuration is created at the
Home screen, you can view map screen
data.
For the most part, this map screen is
similar in appearance to the map screen
used in other Harvest configurations.
However, the Harvest Diagnostic button,
shown at the bottom right-hand side of
the Equipment Tab (A), differs in
appearance from that shown on other
Harvest configuration map screens. This
Harvest Diagnostic button does not
display a picture of a combine.
The top of the Harvest Diagnostic button displays the following information:
• For configurations using a Platform Head or Pickup Head - Swath Width, shown both in units of
measurement and as a percentage total.
• For configurations using a Row Head - Number of active rows.
The Harvest Diagnostic button also displays this information for all CLAAS configurations:
• Grain Flow
• Header Height - shown as a percentage
• Engine Speed - shown in revolutions per minute
• Fuel - fuel consumption of the combine
Note: Elevator Speed information is not shown for CLAAS Quantimeter configurations.
D
IAGNOSTICS FOR
CLAAS Q
UANTIMETER
Diagnostics Screen for CLAAS Quantimeter
When performing a Harvest operation, you can access the Grain Harvest Diagnostics
screen by pressing the Display Information button. Technical support may request that you
look at this screen for help in diagnosing a problem. When the Devices screen opens, press
and highlight the AL Bridge listing in the CAN Device list, then press the Diagnostics button. The Grain
Harvest Diagnostics screen appears.
136 +
116 - 136
96 - 116
76 - 96
0 - 76
Yield
Soybeans
1.06
ac
5.0
mph
Yield
Moisture
Area
Wet Weight
Dry Bushels
Soybeans
118.6
15.9
1.06
6797
111
Swath: 30 ft 0 in 100%
Flow
Header
Engine Speed
Fuel
2205 bu/h
25%
1115 rpm
3 gal/h
Full Swath
Moisture
bu/ac
%
ac
lb
bu