Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 168)

Remote Infrastructure Management System - Version 1.0 / July 2014
168 www.chatsworth.com
8.2.2 Load Configuration Data
1. On the RIM-1000 interface, go to Configuration>Flash Program.
The Flash Program Configuration page displays.
Figure 8.8 Load Configuration File (Flash Program Configuration Page)
2. Click the Browse button to navigate to the location of the configuration file you want to load.
IMPORTANT Make sure you have not changed the three-letter extension (.cfg, .mfg, or .xfg) of the configuration file, or the
RIM-1000 will not recognize it.
3. Once you have selected the file, click the Upload button.
The configuration file is uploaded while the following messages display:
Once the configuration file is uploaded, the RIM-1000 reboots itself.
File has been uploaded and bin file verifed
File will now be copied to flash #2, this will take about 60 seconds
Then verify the file is contained in flash #2 and then press the Copy Flash2 to Flash1 button
If your browser does not automatically redirect to you, please click here