Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 154)

Remote Infrastructure Management System - Version 1.0 / July 2014
154 www.chatsworth.com
5.3.1.1 Bootloader Menu
The bootloader menu is accessed by typing reset at the command prompt. This menu is used to establish IP/TCP and PPP
interaction with the network. The RIM-1000 must be set up with an IP address, Subnet Mask, and default router. These addresses
can be obtained from your Network Administrator or IT Department. To enable the SNMP receiving stations, or to create
communities, the RIM-1000 MIB, provided on a CD with every unit, must be loaded on a system(s) running a Network Operating
System (NOS). This MIB is compiled through standard functions of the NOS. Consult with your Network Administrator for proper
installation of the RIM-1000 MIB on the NOS. Once the MIB is loaded, the RIM-1000 can be discovered and configured over the network.
For proper operation, the IP addresses configured in the RIM-1000 communities must match the IP addresses on the receiving stations.
Only the administrator's username/password may be changed from this menu. All other Web users must be changed via the
Web interface.
Table 5.3 IP Configuration Menu
Command Description Function
mac
Media Access
Control MAC will display the current MAC address for the RIM-1000. The MAC ad-
dress should never be changed on the RIM-1000, if it needs to be changed,
contact CPI.
ip
Internet
Protocol IP is the network address that is part of the TCP/IP protocol
suite for the RIM-1000 to communicate over the network.
nm Subnet Mask nm allows users to configure the subnet mask address for the network.
dg
Default
Gateway dg allows the user to configure the default gateways/router
address for the network.
ping ICMP
ping allows users to send a communication request to other network
device top check for network conductivity.
time Time
time displays the RIM-1000 current time and date. To enter manually, type
time one space then the current time in 24 hour format, including the
seconds. example: hh:mm:ss.
date Date
date displays the RIM-1000 current time and date. To enter manually, type
date one space then the current time date.
reset Bootloader reset allows the user to return to the bootloader menu
id
Firmware
Identification
id displays the current firmware file name and file size.
blank
Firmware
fileCheck
blank displays what firmware files are present in the RIM-1000 memory.
erase
prgm
Erase Firmware
erase prgm allows users to erase the back up firmware file in
the RIM-1000.
Load ptgm
xmodem
Load firmware
file via the
EIA-232
Load ptgm xmodem allows users to upload firmware files via the
EIA-232 using a serial packet transfer with a terminal emulation program.
erase saX
Erase sectors of
memory erase saX allows users to erase the specific sections of
memory from the RIM-1000.