Chatsworth Products CPI Power Management Tool - Manual

CPI Power Management Tool
IIS-736519-001, 02/20/2014, Rev. 1, Tom Tu
800-834-4969 (USA & Canada) • www.chatsworth.com • [email protected]
For international phone numbers, see our website or contact CPI Tech Support.
This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing or
the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
Page 1 of 1
Installation Instructions
1 Safety Information
WARNING: Follow all standard practices when working with
computer equipment
WARNING: Be sure to use sufficient personnel to safely assemble
and install the server.
2 Included Hardware
• Dell ® PowerEdge ® server with CPI Power Management Tool software
preinstalled
• Rails Set
• Bezel
• Power cord(s)
3 Intended Use
This Dell Server is to be installed into the 19”EIA computer rack/cabinet located in
a Data Center.
4 Tools Required
Refer to instructions included with rail set.
5 Assembly Sequence
• Secure the rails to the designated rack space (U) in the rack/cabinet.
• Attach the server to the rails and slide the server in the locking position.
• Connect the female end of power cord(s) to the server.
• Connect the male end of the power cord(s) to a Power Distribution Unit.
• Turn on the server by pushing the On/Off button in front.
6 Server Serial Number:
__________________________________________
7 Registration:
To obtain the Microsoft ® Windows ® and CPI PMT username/passwords, please
register the product by using the following URL:
www.chatsworth.com/pmt-registration
8 Initial Set up:
The following settings are pre-configured on the server. Note that the IP address
in the browser connection to CPI Power Management Tool will change when you
change the IP address to match your network.
• Default Network Settings (change as required):
Gb 1 port (the left network port when facing the back of the server)
IPv4 IP address: 192.168.123.122
Subnet mask: 255.255.255.0
Default gateway: 192.168.123.1
• Browser connection to access software web interface:
http://192.168.123.122:8688/DcmConsole (case sensitive)
9 Documentation:
User’s Manual can be downloaded from the following URL:
www.chatsworth.com/power-management-tool
*Dell and PowerEdge are registered trademarks of Dell Inc.
*Microsoft and Windows are registered trademarks of Microsoft Corporation.