Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 16)

Remote Infrastructure Management System - Version 1.0 / July 2014
16 www.chatsworth.com
1.3. Front Panel Indicators and Controls
Figure 1.1 RIM-1000 2U Front Panel Indicators and Controls
Indicator Description
Expansion Card Relay Status Only available on Expansion Card A, the green LED illuminates when
the relay is active.
Expansion Card #1 LEDs are on the left hand side of
the 1U RIM-1000 enclosure. Expansion cards #2, #3, and
#4 are located across the top of the 2U RIM-1000 enclosure.
Communication Network Status LEDs Link – Green if network link is established. Red if there is no
connection.
Active – Illuminated green when transmitting or receiving data.
Communication Modem Status LEDs
(modem is an optional accessory that must
be purchased separately) TX - Green when information is being transmitted.
RX - Green when if information is being received.
OH - Green when the RIM-1000 Modem detects a dial tone (off hook).
CD - Yellow when if a carrier is detected.
System Status LED Flashes red during initial boot up, approximately 30 seconds.
If the initial boot up fails, the LED continues to flash.
This indicates a condition that requires service; users must contact
CPI for more information.
After the boot up, this LED turns off if no alarms are present, or turns
solid when the unit is in an alarm condition.
Power LED
Green when the power is on.
System Power Switch
Use this switch to turn power to the unit on and off.
Expansion Card #2
Status LEDs
Expansion Card #3
Status LEDs
Expansion Card #4
Status LEDs
Expansion Card #1
Status LEDs
Network Status
LEDs
Modem Status
LEDs
System Status
LEDs
Power
LED
System Power
Switch