Chatsworth Products Remote Infrastructure Management (RIM-1000) - Manual (Page 166)

Remote Infrastructure Management System - Version 1.0 / July 2014
166 www.chatsworth.com
7. From the HyperTerminal menu select Transfer -> Send File. Use the browse button to select the RIM-1000 firmware file from
the computer's directory. The file must be binary and have a .bin extension. Select the file and upload it using the 1K X-Modem
protocol. Then click Send.
8. A transfer status screen will be displayed. The transfer takes about 10 minutes. Once the transfer is complete, the transfer
status window will automatically close. The HyperTerminal window will indicate that the upload is complete.
9. From the FCF Boot prompt, type RUN or power down the RIM-1000 and restart it to verify that the new Flash program runs.
10. Press Enter to display the FCF Main Menu and repeat the steps above to erase and download to the other Flash program chip.
Once the firmware upgrade is complete, disconnect the serial cable and close HyperTerminal.