HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 7)

Introduction 7
• HP Virtual Connect with iSCSI Cookbook
This guide describes how to configure HP Virtual Connect for an iSCSI environment. It provides tips and
troubleshooting information for iSCSI boot and installation.
• HP BladeSystem c-Class Virtual Connect Support Utility User Guide
This guide provides instructions for using the Virtual Connect Support Utility, which enables
administrators to upgrade VC-Enet and VC-FC firmware and to perform other maintenance tasks
remotely on both HP BladeSystem c7000 and c3000 enclosures using a standalone, Windows-based
command line utility.
• Release Notes
Release notes document new features, resolved issues, known issues, and important notes for each
release of the Virtual Connect Manager and support utility.
Virtual Connect overview
HP Virtual Connect is a set of interconnect modules and embedded software for HP BladeSystem c-Class
enclosures that simplifies the setup and administration of server connections. Virtual Connect includes the
following components:
• VC-Enet modules
o HP 1/10Gb Virtual Connect Ethernet Module for c-Class BladeSystem
o HP 1/10Gb-F Virtual Connect Ethernet Module for the c-Class BladeSystem
o HP Virtual Connect Flex-10 10Gb Ethernet Module for BladeSystem c-Class
o HP Virtual Connect FlexFabric 10Gb/24-port Module for BladeSystem c-Class, which provides the
capability to configure Ethernet and FC/FCoE or iSCSI connections
• VC-FC modules
o HP 4Gb Virtual Connect Fibre Channel Module for c-Class BladeSystem
o HP Virtual Connect 4Gb Fibre Channel Module for BladeSystem c-Class (enhanced NPIV)
o HP Virtual Connect 8Gb 24-Port Fibre Channel Module for BladeSystem c-Class
o HP Virtual Connect 8Gb 20-Port Fibre Channel Module for BladeSystem c-Class
• HP Virtual Connect Manager
Virtual Connect implements server edge virtualization between the server and the data center infrastructure
so networks can communicate with pools of HP BladeSystem servers, and so you can upgrade, replace, or
move server blades within the enclosures without changes being visible to the external LAN and SAN
environments. The external networks connect to a shared resource pool of servers rather than to individual
servers. Virtual Connect cleanly separates server enclosure administration from LAN and SAN
administration.
VCM is embedded on the VC-Enet module. You can access VCM through a web-based GUI or CLI. The
Onboard Administrator provides a web link to the Virtual Connect GUI.
The VC modules support the HP BladeSystem c7000 Enclosure, the HP BladeSystem c3000 Enclosure, and
all the server blades and networks contained within the enclosure. FlexFabric modules are only supported in
BladeSystem c7000 enclosures and G6 or newer server blades with Virtual Connect firmware v3.15 and
later.